I have inadvertently introduced a pin drop of bacteriostatic water into my 10ml vial of Test E.This happened several days ago. I didn’t think much about it cuz it was sterile. Now the Test has clouded up significantly. Anyone have any reason why I wouldn’t continue to inject my Test? Thanks
Oil and water don’t… a drop of water shouldn’t be a problem, a lot of water might though.
The water would cause a bit of the testosterone to come out of suspension, as it is not water soluble. Unfortunately this crystallized testosterone will act to bring more testosterone out of solution.
You can continue to use the oil-portion of the solution, but the concentration of dissolved testosterone will be much lower, and of course you have no idea how much is left in solution.
How fast to you think the suspension/level of test would deteriorate?Your really bummin me out lol
Also to note there is not enough water in the vial to stand on top of the oil. Maybe total one pin drop it just clouded the bottle made it look a bit milky. Same like when hydraulic fluid takes on water
Stick a 23 gauge pin in the vial (no syringe) don’t let the needle touch the liquid in the vial.Slowly heat the vial to 250 degrees farenheit until the cloudiness disappears. The moisture should heat and evaporate out the pin.
I’m no expert, just parroting previous posts. Good luck bro,
Do you think I’d run the risk of altering/destroying the test doing that. it sounds risky. How would I raise it slowly hold it in water while I bring it to a boil?