[quote]Dahollow wrote:
[quote]ty_ty13 wrote:
if i’m looking to front load the Test E. on this cycle i’d be looking at about 1.8g on first pin, correct?
also with front loading i’d need to start the AI as soon as my first pin/shortly there after, correct?
i’m also looking at shifting the dbol to the last 4 weeks of the cycle for the reason of if my gains are what i’m looking for on this i may not use it on this cycle.
also im suprised i haven’t had but 2 guys chime in… [/quote]
Front load =
You take the weekly dose + the dosage of that day as first inject.
E.g. 500mg/week of Test E divided into 250 on Monday and 250 on Thursday.
On the first inject on Monday you take 500mg + 250mg = 750mg. On Thursday and following 250mg.
Sides COULD occur when front loading, but as always… Start Adex low and increase only when needed. [/quote]
You can’t just take the weekly dose and add that to the dosage of that day while ignoring the esters. In this case, it comes close to working out because the half-life of test e is close to 1 week. However, if using test with another ester, adjustments will have to be made.
From Bill Roberts:
The amount to use is the amount that is on average taken in one half-life of the drug, plus the injection amount that will ordinarily be used.
So for another example, letâ??s say someone is planning on using 600 mg/week of testosterone enanthate, taken as 200 mg three times per week.
If figuring the half-life at 5 days, then on average the amount taken per half-life (per 5 days) is 5/7 of the 600 mg. That works out to an average of 429 mg taken per 5 days.
So the frontload amount is that amount, plus the usual ongoing amount of 200 mg.
If being highly exact this would work out as 629 mg, but as 600 mg is a more convenient figure, this would be more than close enough. Thereâ??s no problem in rounding the number a little.
So on Day 1 the injection would be 600 mg. This would not produce unusually high levels, but instead would promptly get levels to where they need to be.