So I have been using AAS for close to 7 years now. I am 5’9 230 about 18-20% BF. I have NEVER HAD post injection pain or swelling like this before. I typically have ran either Test C or E 200-250 when I inject usually about 1 cc. Even injecting with Tren E 200. I have never had this before.
Now two injections in a row for .5cc of Test e 400(new dose of this compound for me) I have extremely inflamed deltoid, seems like fluid retention into my bicep and triceps and just firm, warm, and red.
I inject with a 23 G 1 1/4” needle. Anyone have any ideas what’s going on? I train through the pain but normal daily task such as putting in a shirt become tough with lifting my arms above shoulder height.
I appreciate any insight is it’s the higher dose Test E? Is it my body telling me I need to keep tren in the syringe with the test ?
This is your problem. They use a ton of solvents to make that high concentration. It’s not gonna get any better. You either have to cut it or toss it.
I would toss it and get something under 300mg/ml. Even that can give some issues.
Thank you! When I was dosing Tren E with it I feel like that might have broken it down some but since I got off that it’s been miserable. It’s like my felt is full pump on one side with zero definition and just painful.
I ordered test E 250 will be excited to start that and have test prop I’ll run three days a week at about 100mg a shot until the new test e gets in. Thank you!
When I brewed my own gear I had no issues getting 250mg/ml of test e into solution without a solvent. When you try to increase the concentration over 300mg/ml you have to add a solvent. No way around it. Some people react to solvents. I would not be surprised if the 400mg dose you were/are taking is “crashing out” when in your tissue. Which would certainly cause discomfort in the site.
?
