Quick question, is there any readily available oil one can use to dilute concentrated gear? I’m in for a world of hurt if not. I do have benzyl alcohol handy.
grapeseed
Thanks, 10% BA seem about right?
[quote]c.m.l. wrote:
Thanks, 10% BA seem about right?[/quote]
WHAT FUCK NO. 10% will leave you crippled. .02% is more than enough for making gear. But if your just cutting it you don’t need any more BA. Half the reason your cutting the gear is to lower the BA. If you add 10ml of fluid to cut it with a 10% BA count your using 9ml of oil and 1ml of BA. To show you how over kill this is when you make 100ml of Test you only use .018 or .02% BA. That 2mls max of BA for 100ml of gear. Your gonna hate life if you add that much BA. I would just filter the oil and then add the oil to gear.
Filter it huh, with what number filter. Also according to what I’ve read 9 or 10% is pharmacy standard, and if the irritation Is caused from the solute concentration rather than the BA concentration then more oil with equivalent BA should do it. Perhaps i am mistaken, thanks for info btw. I have made hcg bs water with .02 percent I assume gear was different.
get some 0.22 filters, filter the oil, then put it back in the vials. Be careful, the oil has to remain somewhat sterile.
[quote]c.m.l. wrote:
Filter it huh, with what number filter. Also according to what I’ve read 9 or 10% is pharmacy standard, and if the irritation Is caused from the solute concentration rather than the BA concentration then more oil with equivalent BA should do it. Perhaps i am mistaken, thanks for info btw. I have made hcg bs water with .02 percent I assume gear was different.[/quote]
Been doing this quite a while and the highest I have E er heard of was 4% when making prop or suspension.
I’ll probably do something like thst, I’ll mix in syringe before pin so if it’s bad I can just pitch it. I wonder why you use more BA for short ester
Sounds like your getting ba and bb mixed up?