[quote]SwD wrote:
I see. Thanks guys. At last I “get it”. Seems to me then that peptides are a much better option.
BTW, even though this thread is called “GHRP-6 Advice”, I’ve seen many posters here actually recommend GHRP-2 instead. Less sides, less appetite, etc. Is that accurate?
[/quote]
I’m not an expert, but while GHRP-6 is the least expensive of the compounds, it also has a side effect of causing extreme hunger for some. Ipa or GHRP-2 do not appear to have this side effect while being just as effective.
[quote]waylanderxx wrote:
Oh and incase anyone cares, a friend of mine has been using ghrp6 for about a month now with the addition of cjc 1295 no DAC the past 2 weeks and got blood work done.
His IGF-1 level was 342.0 ng/ml with the normal range being 117-329, so this stuff works.[/quote]
Just out of curiosity, what kind of dosage is he using? and how often?[/quote]
200 mcg ghrp6 with 100 mcg cjc 1295 no dac everyday upon waking and after training.[/quote]
Is this protocol being used on a true ED basis or just training days? Based on the peptides inability to supress endo GH I would presume a 5on 2off schedule would not be needed.
[quote]Lurxalot wrote:
sorry to bump but didnt want to start my own dumb thread…
what size syringes is every one using? 29 or 30’s i assume for sub-q
also, do you just get one syringe then replace the needle?
if any one wouldnt mind posting - or PMing me - where they get syringes from i’d appreciate it
thanks[/quote]
If I were to do this protocol, I would utilize my 29 or 30 (can’t remember which it is) gauge insulin pins that I use to administer my TRT shots.
You can’t replace the needles of an insulin pin.
I would reuse the same slin pin until it became too dull (probably after 2-3 days of 3x/day). You can tell it is too dull when it starts to hurt when you jab…bruising also seems to ensue.
Note you can get more life out of your slin pin by minimizing the number of times you have to puncture the vial and draw out your peptide. You can hold about a day’s worth of combined G6/MOD GRF in one pin if you reconstitute correctly.
Obviously you would want to thoroughly clean the needle and injectoin area before each jab.
[quote]Lurxalot wrote:
sorry to bump but didnt want to start my own dumb thread…
what size syringes is every one using? 29 or 30’s i assume for sub-q
also, do you just get one syringe then replace the needle?
if any one wouldnt mind posting - or PMing me - where they get syringes from i’d appreciate it
thanks[/quote]
If I were to do this protocol, I would utilize my 29 or 30 (can’t remember which it is) gauge insulin pins that I use to administer my TRT shots.
You can’t replace the needles of an insulin pin.
I would reuse the same slin pin until it became too dull (probably after 2-3 days of 3x/day). You can tell it is too dull when it starts to hurt when you jab…bruising also seems to ensue.
Note you can get more life out of your slin pin by minimizing the number of times you have to puncture the vial and draw out your peptide. You can hold about a day’s worth of combined G6/MOD GRF in one pin if you reconstitute correctly.
Obviously you would want to thoroughly clean the needle and injectoin area before each jab.[/quote]
I would add to never use a needle again if there was any trace of blood. But I am overly cautious, so take that as you may.
Considering hopping on the GHRP-6 and CJC train.
I don’t really have much experience with peptides or reconstitution, so bear with me.
Questions I have:
When reconstituting with bac water, how do you calculate how much bac water to add?
For example, how would I reconstitute a 5mg vial of ghrp-6 and then calculate resulting dosages?
When pairing CJC with GHRP-6, what dosage relation do you usually run?
If I’m going to run it, I’ll likely do 100micro of GHRP-6 upon waking up, PWO, and before sleeping. What would be the optimal CJC dosing to go with this?
Injections are subQ, but while I have some experience pinning others intermuscularly, I’ve never done a subQ. Any advice or information on the matter would be appreciated.
[quote]Blaze_108 wrote:
Considering hopping on the GHRP-6 and CJC train.
I don’t really have much experience with peptides or reconstitution, so bear with me.
Questions I have:
When reconstituting with bac water, how do you calculate how much bac water to add?
For example, how would I reconstitute a 5mg vial of ghrp-6 and then calculate resulting dosages?[/quote]
You have to answer #2, before you can answer #1, so the actual dosages you want to run will influence your volume of reconcentration (to make it easier when drawing into the slin pin).
A good rule of thumb is to use BAC water in a 2:1 or 1:1 ratio of Peptide:BAC, keeping in mind that some vials just won’t hold BAC at a 1:1 ratio. So that would give you 1 mL BAC for every 2 mg of peptide.
For 100 mcg/dose of G6 (which usually comes in 5 mg cakes) use 2.5 mL of BAC water, and draw up to ‘5’ on the slin pin.
For 100 mcg/dose of CJC (which usually comes in 2 mg cakes) use 2 mL of BAC water, and draw up to ‘10’ on the slin pin.
[quote]
2) When pairing CJC with GHRP-6, what dosage relation do you usually run?
If I’m going to run it, I’ll likely do 100micro of GHRP-6 upon waking up, PWO, and before sleeping. What would be the optimal CJC dosing to go with this?[/quote]
100 mcg of each will be fine. What is your body weight?
Good rule of thumb is 1 mcg per kg of bodyweight, without exceeding 125 mcg of either per dose (lot of people don’t go over 100 mcg of CJC due to cost and difficulty in reconstituting ‘odd’ dosages of it with a 2 mg cake).
[quote]
3) Injections are subQ, but while I have some experience pinning others intermuscularly, I’ve never done a subQ. Any advice or information on the matter would be appreciated.
[quote]VTBalla34 wrote:
A good rule of thumb is to use BAC water in a 2:1 or 1:1 ratio of Peptide:BAC, keeping in mind that some vials just won’t hold BAC at a 1:1 ratio. So that would give you 1 mL BAC for every 2 mg of peptide.
For 100 mcg/dose of G6 (which usually comes in 5 mg cakes) use 2.5 mL of BAC water, and draw up to ‘5’ on the slin pin.
For 100 mcg/dose of CJC (which usually comes in 2 mg cakes) use 2 mL of BAC water, and draw up to ‘10’ on the slin pin.
[/quote]
so would you use the same ratio when reconstituting with mineral oil?
i have about 20 vials of G6 and CJC no DAC but keep thinking im gonna fuck up - lol
i got a question… i’ve had some vials that i’ve been keeping at room temp in their orignal packging away from sunlight but the cakes look broken and kind of “puffed” up in some cases. been about two weeks since i got em and just now getting a chance to recon
[quote]MAF14 wrote:
i got a question… i’ve had some vials that i’ve been keeping at room temp in their orignal packging away from sunlight but the cakes look broken and kind of “puffed” up in some cases. been about two weeks since i got em and just now getting a chance to recon[/quote]
There was no question mark, but I assume you are asking if they’re still good?
first of all thanks for all the help. i havent had internet in my apt for the last 2 weeks so its rare i can bring my laptop out to a place w/ wifi…
i’ve dont two injects so far, but no hunger. should i be worried? 100 mcg’s of each i think i’ve heard of people not getting hungry… ive been doing the intermittent fasting thing for the last 1.5 years so maybe that could have some thing to do with it?
idk maybe i’ll try a 200 mcg dose and see if the hunger kicks in
another thing is when i first recon’d the vials i (STUPIDLY - i think) added air into them forgetting how fragile peptides are so when i pulled the pin out some water shot out of each vial. im hoping when the water shot out the pressure was released enough not to damage them. thoughts?
EDIT: did a double dose and got a bit hungrier than normal PWO but only lasted about 10 mins and took about 45 to kick in
one more question though… i tried doing the math myself but ended up just getting frustrated and pissed off
i have 31G, 1cc pins and was planning on doing 2-3 injects per day of 100 mcg G6 and Mod GRF
if anyone else uses these numbers, how much volume would i inject for a total 200 mcg dose (half of each)
thanks[/quote]
Here’s the math: (GHRP-6) 5000mcg/5ml = 100mcg/x ml. Cross multiply and reduce. So 5000x = 500/5000, so x= 0.1ml. Got it?
For MOD GRF: 2000mg/2ml = 100mcg/x ml so 2000x = 200 and 200/2000 = 0.1 ml.
Therefore if you dilute the G6 with 5ml BAC water, you get 100mcg per 0.1ml, and if you dilute the GRF Mod with 2ml BAC water, you get 100mcg per 01.ml also.